Robot Programmer

Summary

Program robots by performing the following duties under the direction of the robot programmer supervisor.  Experience with FORD,STELLANTIS or GM standards is a plus!

Essential duties and responsibilities include the following. Other duties may be assigned

  • Reviews drawing package for correct interface, verifies that the interface matches application
  • Powers up robot and Calibrate
  • Downloads OLP programs
  • Set up Binding Table / I/O
  • Configures Robot D-Net / I/O Communication
  • Teaches robot path programs: Weld, Material Handling, Maintenance, Tip Dress etc.
  • Set up signals between Robot / PLC interface
  • Debugs programs in slow speed and verify all signal’s to and from the PLC
  • Mounts hard stops accordingly
  • Set up Software Limits to match hard stops
  • Debugs auto repeat with PLC Programmer
  • Assists pipefitter & electrician with resolving robot dressing problems
  • Runs metal and verifies weld spot locations
  • Makes necessary changes to achieve cycle time
  • Documents all changes to robot programs and End-Effector sequence changes
  • Supports FIS / Tech Review / 20 hr. / 2500 cycle run
  • Assists with customer buy-off
  • Participates in TR studies as required
  • Documents all broken robot equipment that has been replaced
  • Backs up robot programs and parameters to assigned secure drive
  • Understands and follows safety and environmental regulations and identifies safety/environmental concerns
  • Adheres to the Quality System and participates in continuous improvement
  • Conducts themselves during installation in the field as a CLIENT representative
  • Provides all backup and documentation to Robot Leader after project is installed and running productionRegular and predictable attendance is an essential function of this job
  • Works alongside with PLC debug group as a team

Qualifications

To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

Education and/or Experience

Associate’s degree (A.A.) or equivalent from two-year College or technical school and 2 year’s related experience and or training; or equivalent combination of education and experience.

Travel Requirements

Local travel to CLIENT facilities and customer/supplier sites for meetings or support is occasionally required.  Travel requirements may vary based on project assignments and department workloads.

 

**Send resume to therrin@automationmovers.com**

Job location: Sterling Hts.